Sprockets for Double Plus Chain/Center Roller Chain
- Sprockets for Double Plus Chain and Center Roller Chain.
- In addition to the Pilot Bore Series, the Fit Bore series which allows you to pre-select and add finishes such as shaft bores, keyways, and set screw finishes, is also available.
Features
- *Can be used with Double Plus Chain with snap covers.
- *Uses carbon steel for machine structural use, and both hardened teeth and unhardened teeth specifications are available.
- *Available chain sizes :RF2030~RF2080
Note) When selecting sprocket specifications
・It is necessary to select a sprocket specification that corresponds to the customer's operating environment and the chain specification used. For details, please refer to the compatibility table for each chain and sprocket.
・Shaft bore remains as a pilot bore, so it must be machined by the customer before use. Click here if you require a product with a finished bore
ベアリング穴加工をご要望の場合はこちら Click here if you require a product for keyless lockingCatalogs ・Instruction Manuals
Model No. examples
RF2040VRP | - | 10T | Q |
| Size |
| Number of teeth |
| Tooth hardening None :Teeth not hardened Q:hardened teeth specifications |
List of Model Numbers
※Click the model No. for detailed information.
Applicable chain no. | Model No. | Calculated no. of teeth |
---|---|---|
RF2030 | RF2030VRP-10T | 10 |
RF2040 | RF2040VRP-10T | 10 |
RF2050 | RF2050VRP-10T | 10 |
RF2060 | RF2060VRP-10T | 10 |
RF2080 | RF2080VRP-10T | 10 |