Sprockets for Water Treatment Chain

Product photo
  • Chain life is greatly affected by how it engages the sprockets.
  • These tooth block sprocket developed for corrosion and wear resistance can be manufactured to meet any material or dimensional requirements.

Features

Reduce cost by changing from cast integrated type to Block Replaceable Teeth form.

Easy to handle and environmentally friendly with a hybrid structure of tooth SCS material and tooth mounting base SS material

Model No. examples

ACS13078W - 1C 11T Q - BK

Available chain sizes



Number of teeth

Teeth hardened

Type
No symbol :Integrated type
BK:Block Replaceable Teeth
RK:Ring Replaceable Teeth (D-split)
No. of strands / Hub type

Integrated type Block Replaceable Teeth Ring Replaceable Teeth (D-split)

Tsubaki also provides sprockets that can satisfy the type, material, or dimensional requirements of any main or drive chain, so please contact us.

Sprockets for Water Treatment Chain

  • 1. Please select the sprocket shape type from the table below.
  • Construction Package symbol
    Integrated type No symbol
    Splid Solid (C-split ) TS
    Block Replaceable Teeth BK
    Ring Teeth (D-split ) RK
  • 2. The material combinations are as shown in the table below.
  • ※If the teeth material is SCS2 or FCD600, the teeth hardening is applied.
    Construction Material
    Hub ・Arm Casting structure SCS2、FCD600、SCS13
    Welded structure SS400+S25C(Hub and Arm )
    Teeth Integrated type ・TS(C-split ) SCS2 or FCD600
    RK(D-split ) Choose either SCS2 or plastic.
    BK(Block Replaceable Teeth ) SCS2
  • 3. If the distribution of hub length is different on the left and right, please specify each dimension.
  • 4.Since the painting specifications differ depending on the designated government office, etc., please be sure to refer to the customer's specifications before instructing.
    Painting for our standard pilot bore product is a zinc rich primer once. Finishing bore products are zinc rich primer once and epoxy resin twice.
    No paint for plastic, SCS13, and stainless steel 300 series. As a common rule, apply prebin oil to the shaft bore and hub end face.
  • 5. Please specify in the drawing etc. to clarify the specifications.